Posted on

Morco FEB24 Combi Boiler Range Hydraulic Assembly Unit

MCB2191 and MCB2193 for the FEB24E, FEB24ED and FEB24ED3* are no longer available.

It is now necessary to decide which parts of the hydraulic assembly need to be replaced and the unit will need to be repaired prior to re-installing into the combi boiler.

The following options are available to repair hydraulic assemblies:
MCB2257 – Hydraulic valve Kit
MCB2160 – Plate heat exchanger
MCB2335 – Washer and O ring Kit

Below lists parts within a Hydraulic valve kit (MCB2257) that are included either loose or preassembled with their availability to purchase on an individual basis;

MCB2192 – Diaphragm housing
MCB2255 – Diaphragm

Posted on

Morco Water Heaters

Morco water heater models D61E, D61B and MP6 (PRIMO6) have now been discontinued and superseded by EUP6.

New regulations came into force in recently which state that water heaters must have lower Nitrogen Oxide (NOx) emissions. This EUP6 water heater is fully compliant, meeting all of the requirements for these new regulations.

Posted on

Morco Instantaneous Water Heaters

Morco Instantaneous Water Heaters, D61B/E and the G11E are now discontinued, superseded by the PRIMO6 and PRIMO11 Respectively. The PRIMO6 has almost identical dimensions to the D61B/E and the PRIMO11 to the G11E, making them a direct replacement. The new heaters will accept the existing flues. A fitting kit PRIFK will be required for PRIMO6 installation and EUPFK for PRIMO11 installation.